1. Begin the machine and see the following interface,
2. Wait a moment, see the image under
three. Press F1 to enter the machine settings page, select 'SystemSettings', and press Enter
4. Pick the first solution 'Adapters and UEFIDrivers'
five. Enter straight
6. Pick 'PciRoot (0x0) / Pci (0x2,0x2) / Pci (0x0,0x0)' and press Enter
7. Enter the quantity '1' and press Enter
eight. Click 'start' to enter the webbios graphic settings page
9. You can see you will discover 8 tough drives around the server, each difficult drive is close to 600G, click 'ConfigurationWizard' around the left to enter the array setup wizard
Description:
ClearConfiguration (clear configuration): clear the current configuration info, spend focus to lose all information. NewConfiguration (new configuration): clear the current configuration details, and develop a new configuration. AddConfiguration (add configuration): retain the original configuration facts, and add a brand new hard drive towards the original configuration. (This configuration ordinarily does not trigger information loss, but this operation is risky, it is advised to back up the information very first!) Note: In case you select the initial two solutions (ClearConfiguration and NewConfiguration), all data will likely be lost! Please backup all information initial! If it really is a brand new machine, usually do not be concerned about this item.
10. Choose 'NewConfiguration' right here and click 'next'
11. Click 'yes'
12. Direct 'next'
13. Click around the left side to select the disk, after which choose AddToArray to add the chosen challenging drives towards the suitable Drivegroups in order. Due to the raid5, I will add all of the left eight difficult drives towards the appropriate Drivegroups
14. Click 'AcceptDG' immediately after creation
15. Click 'yes'
16. Click 'AddtoSPAN' around the left
17. Click 'next'
18. Pick RAID5 for the RAIDLevel around the left, the 'SelectSize' quantity is set according to the number around the right, other default, click Accept
19. Click 'yes'
20. Mouse pick VD0 around the right and click 'next'
21. Click 'Accept'
22. Click 'yes'
23. Click 'yes'
24. Click 'Home'
25. Click 'Exit' around the left
26. Click 'yes'
27. Enter directly and enter the following image to prepare to install the method
Listed here are the actions to install centos, you'll be able to refer to the specifics:
CentOS5.4 complete installation graphic detailed tutorial
http://www.467.cn/shownews_598.html
Centos 5.x version graphic installation guide and safety configuration
http://www.467.cn/shownews_568.html
LinuxCentOS6.0 graphic installation tutorial
http://www.467.cn/shownews_336.html
Summary: It is mainly because the hard disk of this machine is directly connected to the riad card by SAS. Configure RIAD and you are OK. Should you only have a single difficult disk, configure RIAD0, and configure RIAD1 for two.
Or when SD Card accidentally deleted Video recovery software got a strong hands-on potential, you can open the case and connect the really hard disk cable directly towards the motherboard. It can be also feasible not to pass the riad card.
In SD CARD are a rookie, you may do nothing, there is a way, use IBM's boot disk, if there is no boot disk, visit the IBM official web page to download, download the newest 9.four boot disk, then guide each of the way, usually do not choose the program Select, straight pick the riad configuration, configure the reboot, then make use of the centos method disk to boot, anything is OK, but the boot disk is slower, wait for ten minutes.
Comments